product name:2.4G mini remote control coding:vanpro-2.4MINI
product data:
Name: vanpro 2.4G mini remote control (including receiver) Applicable: electric skateboard, RC model car Colour: Black Number of channels: 2 Frequency: 2.4G Signal: PWM Distance: 80 meters Battery: 2 AA batteries can be used for a long time Function: forward, reverse, brake, (RC model car can turn left and right) linear acceleration Steering gear to fine-tuning, throttle speed fine-tuning Plus electronic switch can be achieved on the control of the lamp, the installation of resistance 330Ω can self-locking switch lamp power supply. Advantages: signal stability can break through the metal shield, remote control distance. On code: 1. Turn on the receiver first, then press and hold the transmitter on the code button, and finally Turn on the transmitter switch for a few seconds and drop a few times to succeed ESC: Suitable for all models on the market with ESC, PWM signal driver. The following is how the transmitter and receiver code: ??1. Insert the supplied two-pin black-pair connector into the receiver 4 / B channel. ??2. Insert the three lines of the ESC line into the white channel, the middle red line (positive), the edge black line (negative) into the 2 channel. ??3. will be electric, the motor three pairs of plug, electrical adjustment battery red and black corresponding to the color power cord plug on the plug (check positive and negative to ensure correct) ??4. Turn on the power supply comes with power switch power, then the remote control receiver blue light continues to flash. ??5. Install the hand-held transmitter battery standard on the 5th battery. ??6. Hold down the lower right corner of the transmitter black on the code button, the left side of the black power switch to the ON position, then the transmitter power light began to flash red, continuous flashing about 5-6, hear the "drop "Drop" "drop" three sound, the receiver blue light and the transmitter red light has become a long bright release black code key, the code success. Unplug the two-pin black-to-code plug and press the transmitter button to start the motor. ??7. The next boot does not require the insertion of two PIN black plugs. First turn on the power switch to the ON position power, the transmitter on the left side of the black power switch to the ON position, this time will hear the "drop" "drop" "drop" three sound, the success of the code (there may be more individual Wait a few seconds to ring). Press the transmitter button to start the motor. |
Physical display:
|
|||
|